Construction Steps
Watch each construction being drawn, one step at a time, and pick the step that comes next. Bisectors, perpendiculars, parallel lines, equal parts, angles and triangles (SSS, SAS, ASA, RHS): all 15 Junior Cycle constructions. Stuck? The rules and a step-by-step viewer are just below the game.
Choose your round
Tip: you can also answer with the keys 1, 2, 3 and 4. In Construction Steps, every 5 in a row gives you 3 bonus seconds. The newest step is drawn in red.
Junior Cycle Maths learning outcome: GT.3a (2018 specification)Constructions
Spot the pattern
Draw a line segment [AB] and construct its perpendicular bisector (the steps are in the viewer below). Now pick any point on the bisector, call it X, and measure |XA| and |XB|. Try two more points.
- What do you notice about |XA| and |XB|, wherever X is on the line?
- The arcs you drew from A and B had the same radius. How does that explain where C and D are?
- So why does the construction need the compass to be more than half of |AB|?
Show me
Every point on the perpendicular bisector is the same distance from A as from B. C and D are on arcs of the same radius from A and from B, so each of them is that same distance from both ends, and the line through them is the bisector. If the compass is open to half of |AB| or less, the two arcs never meet, so you need more than half.
The tools
Watch each construction, step by step
Pick a construction, then tap Next step. The newest part is drawn in red.
The 15 Junior Cycle constructions
- 1. Bisector of an angle (compass and straight edge only)
- 2. Perpendicular bisector of a line segment (compass and straight edge only)
- 3. Line perpendicular to l, through a point not on l HL only
- 4. Line perpendicular to l, through a point on l
- 5. Line parallel to l, through a given point
- 6. Dividing a line segment into 2 or 3 equal parts, without measuring
- 7. Dividing a line segment into any number of equal parts, without measuring HL only
- 8. Line segment of a given length on a given ray
- 9. Angle of a given size with a given ray as one arm
- 10. Triangle, given three sides (SSS)
- 11. Triangle, given two sides and the angle between them (SAS)
- 12. Triangle, given two angles and the side between them (ASA)
- 13. Right-angled triangle, given the hypotenuse and one other side (RHS)
- 14. Right-angled triangle, given one side and one of the acute angles
- 15. Rectangle, given the side lengths
Triangles: which data?
Where this shows up in the exam
Constructions are on the course for both Higher and Ordinary level (constructions 3 and 7 are Higher level only). Expect a part of a geometry question that asks you to construct something accurately in the space given, and sometimes to measure a length or angle on your construction or explain why it works.
How marks are won and lost
- Leave all your construction arcs showing. If the examiner can't see the arcs, it looks measured, not constructed.
- Be accurate. Lengths and angles are checked against the true values, so small errors can cost marks. Use a sharp pencil and set the compass against the ruler.
- Use the right instruments. "Using only a compass and straight edge" means no protractor and no measuring.
- Label the points the question names, and finish the job: join up the triangle, draw the final line.
Try these exam-style questions
Written by Léim in the style of the exam (not taken from past papers). Do each one on paper with a compass, ruler and protractor first.
- Perpendicular bisector. Draw a line segment [AB] of length 9 cm. Using only a compass and straight edge, construct the perpendicular bisector of [AB]. Label the point where it meets [AB] as M. What should |AM| be? Measure to check.
Show the worked answer
Open the compass to more than 4.5 cm (say 6 cm). With the point on A, draw arcs above and below [AB]; do the same from B with the same width. Join the two crossing points. Leave all the arcs showing. M is the midpoint, so |AM| = 9 ÷ 2 = 4.5 cm.
- A triangle (SAS). Construct the triangle PQR with |PQ| = 8 cm, |PR| = 6 cm and ∠QPR = 55°. Then measure |QR|, correct to one decimal place.
Show the worked answer
Sketch it first. Draw [PQ] 8 cm long. At P, use a protractor to draw an angle of 55° with [PQ] as one arm. Set the compass to 6 cm, put the point on P and mark R on the new arm. Join R to Q. |QR| should measure about 6.7 cm (anything from 6.6 cm to 6.8 cm shows an accurate construction).
- Equal parts. Draw a line segment [CD] of length 10 cm. Without measuring, divide [CD] into three equal parts. Show all your construction lines. How long should each part be?
Show the worked answer
Draw a ray from C at an acute angle to [CD]. With any compass width, step off 3 equal marks along the ray from C. Join the third mark to D. Through the other two marks draw lines parallel to that join. They cut [CD] into three equal parts, each 10 ÷ 3 ≈ 3.3 cm.
- Bisect an angle. (a) Draw an angle ∠XYZ of 70°. (b) Using only a compass and straight edge, construct the bisector of ∠XYZ. (c) What size should each half be? Measure to check. (d) Explain why the bisector cuts the angle exactly in half.
Show the worked answer
(a) Use a protractor, starting at 0° on [YZ. (b) Compass point on Y: an arc crossing both arms. From each crossing point, with the same width, draw arcs that cross inside the angle. Join Y to that crossing point. (c) 70° ÷ 2 = 35°. (d) The two triangles formed have all three sides equal (two equal radii from Y, two equal arcs and the shared side), so they are congruent and the two angles at Y are equal.
Came up in: we'll link the past-paper questions that use this topic here soon.
3 pages: rules, 34 practice questions, answers. Free to print for home or class.
Teachers: want a full class lesson on this? Get the Constructions Teacher Pack (€5): Step Sort cards, Construction Dominoes, poster and worksheet.
Parents: get the free guide
How to Get Your Child into College: CAO points, the Maths bonus, entry requirements and every other route in, in plain English.